Windows® XP includes the drivers needed to recognize your Iomega® drive. The native drivers included in Windows XP should assign your drive a letter in My Computer. If your Iomega drive is not being assigned a drive letter in My Computer, please refer to the following document for additional help: http://www.iomega.com/europe/support/english/documents/11078e.html
You must use IomegaWare version 3.1 or higher in Windows XP for Iomega-specific features, such as disk protection. The current version of IomegaWare is available from our Software Download site at
http://www.iomega.com/software/index_en.html
Important: Using earlier versions of IomegaWare in Windows XP may cause your computer to blue screen or be unstable.
Note: You may receive the error message "Setup found hardware or software on your computer that might not work with Windows XP" when upgrading from another operating system to Windows XP. If you are receiving this error during an upgrade, please go to http://www.iomega.com/europe/support/english/documents/11161e.html
| The following Iomega drives and software are supported with Windows XP
|
|
|
| The following Iomega drives and software work with Windows XP native drivers but are not supported by Iomega
|
- Peerless drive system USB and FireWire
- Jaz® 1GB drive
- Jaz 2GB drive
- Jaz Traveller
- PocketZip (Clik!) PC Card drive
- PocketZip (Clik!) USB Dock
- Iomega Microdrive
- FotoShow Digital Image Center
- HipZip Digital Audio Player
- CompactFlash
- SmartMedia
|
|
The following Iomega drives and software will not work with Windows XP
|
|
|
For more information on Windows XP, visit the Microsoft® Web Site at http://www.microsoft.com